Intermountain Gas 251015 Nampa Construction

IPUC Construction Inspection
Inspector(s): Galli,Brooks Date(s): 251015
Company/Owner: Intermountain Gas Company (IGC) Unit/OPID: 08160
Address: 4342 S Red Sox Way City/District: Nampa
Contractor/Job #: W012372610 Foreman: Operator Supervisor: None
Nathan
Von Tuchlinski_
Job Description: 3/" Service Line System Type: © GD ❑ GT ❑ GG
One-Call Ticket: 2025401555 Total Inspection Days: 2.0
Tasks: Procedure# Rating Comments
1. Materials—Handling, Storage, Labeling OPS 11 SAT %" inch dated 08/2025
2. Trenching/Boring—Depth, Clearance OPS 308 SAT 24 inches
OPS 322
3. Bedding/Backfill OPS 308 SAT Sand used
SF 418
4. Pipe Installation(Tracer Wire) OPS 308 SAT 14 gauge observed in trench
OPS 322
5. Valve Installation OPS 703 N/A
6. Coating Condition OPS 401 N/A
OPS 403
7. Manuals—Field Procedures, O & M SAT
8. Testing—Pressure, Duration, Type OPS 505 SAT 96 psi for 15 minutes
9. OQ Qualifications OPS 800 SAT Verified
10. Casing Seal/Installation OPS 325 N/A
11. Service Line Installation OPS 302 SAT
12. Tie-In/Hot Tapping OPS 600 N/A
13. Meter Location/Regulator Testing OPS 302 SAT 3 feet away from electrical
14. Equipment Calibration Verification OPS 501 SAT Verified
15. EFV Installation OPS 301 SAT EFV 1200
16. MAOP OPS 602 N/A
OPS 606
OPS 900
OPS 1000
17. Purge OPS 603 N/A
18. Safety Equipment SF 418 SAT Fire Extinguisher
SF 422
19. Abandonment OPS 607 N/A
20. Line Locating OPS 611 SAT Hand dig to locate stub
IPUC Form 4 Rev. 12/10/2024

IPUC Construction Inspection
21. Plastic Pipe OPS 307 SAT Observed V Met-Fit Install
- Joiner(s) Qualified OPS 309 Observed squeeze off
- Fusion Tools OPS 325
- Squeezing OPS 800
- Heat Plate
- Joining Procedure
22. Steel Pipe OPS 200 N/A
- Welder(s) Qualified OPS 201
Pipe/Coating—Inspected/Repaired OPS 202
- Cathodic Protection OPS 306
-Non-Destructive Testing OPS 401
-Welding Procedures OPS 407
- Removal of asbestos wrap OPS 402
- Exothermic Welding OPS 403
Additional Comments:
Observations included(4342 S Red Sox Way,Nampa, ID): Safety equipment, valid dig ticket, verified
operator qualifications, verified equipment calibration, hand dig to locate stub, correct trench depth,
verified proper installation of V Met-Fits, tracer wire installation, successful pressure test, squeeze off,
bedding and backfill. All observed procedures were followed in accordance with IGC Operations and
Maintenance Manual.
Corrective Action Required: ❑ Yes ® No Compliance Letter#: NA
Lead Inspector: Galli Date: Reviewer: Brooks Date:
251015 IFS
Signature: Signature:
IPUC Form 4 Rev. 12/10/2024